Drain Cleaning and Blockage Solutions

Drain and Pipe Cleaning

Hello friends.

Very often, customers have asked about cleaning the drain or a sewer pipe without resorting to technicians etc. Basic cleaning can be performed with baking soda. Dissolve one teaspoon of baking soda in a glass of water and pour it down the kitchen sink. Wait half an hour, then rinse with a large amount of hot water. This will wash away the remnants of fat from your trap and help avoid blockage in the future. In fact, most types of cleaning you can do on your own – you don’t need a license or special knowledge. Almost every house has a small hand plunger or snake, with which you will be able to remove all blockages in traps and washrooms of your household.

drain blockage

If you’ve got a clogged sewer, you can just rent a mechanical snake from Home Depot and run it on the spot where backup originates from – that’s usually the floor drain. You can also use chemical solutions to clean your pipes, but make sure that they are not aggressive to the materials from which your pipes are made of (copper, cast iron, or plastic). Also pay attention to your own safety – is advisable to use rubber gloves and goggles.

If you have trouble cleaning any drain, fully or partially, don’t hesitate to contact us. We have powerful manual and mechanical snakes of all sizes, we can easily alleviate any blockage in your kitchen, washroom, shower, or sewer.

Sometimes we might need to install a cleanout, to ensure penetration of the snake into the pipe. If the problem persists on the main sewer line even after snaking, we recommend a camera inspection, which will help us to evaluate the state of your tubes and establish the problem.

We, AAADrain experts have extensive knowledge and experience in service, maintenance, and replacement of drains and sewer systems. We are fully licensed, insured, approach every task responsibly and offer sensible solutions.

Get in touch, and stay dry.

Building Trap Removal & Replacement

Building trap removal and replacement

Hello friends.

Today we would like to tell you more about building traps. As we’ve written about them before, we can clean it up and remove the blockage by a snake or plunger, but considering it’s specific design features we can not clear it completely.

Nowadays, each device has its own sanitary trap and therefore the presence of building trap is not only useless, but also problematic.

Why is that? It’s presence in the sewer line leads to the formation of blockage, which can cause flooding in your basement. The problem was so serious that in the 60s the sanitary building code had to be changed.

Very often tree roots find their way into traps and start growing, which is also a potential cause of blockage, running backup, and can cause cracks in these parts of the sewer system. The presence of the building trap on the main sewer line makes it impossible to clean the pipes completely and fully inspect the whole sewer system .

When the sewer system works well, most people do not even know about the existence of a building trap on the sewer line. Building trap is located close to the front wall, and can be either inside or outside the house.

Based on the aforementioned reason, and particularly given the fact that the building trap is on the main sewer line, even a little clogging can lead to running backup and the inability to use the drain system fully.

Therefore, we, AAADrain experts, recommend building trap removal. We have got 15 years of experience in our arsenal, we conduct building trap removal and replacement with a 2-way cleanout instead. 2-way cleanout significantly aids the process of cleaning and inspection with a camera and, if necessary, cleaning with snake.

building trap removal and replacement

Each replacement entitles you to a camera inspection of the whole sewer system.

Guarantee for such work is 20 years, just as our work on full and partial drain replacements.

Stay dry.